SEARCH - Equipment (Mounted)

USED 26.6' X 102 VANBODY GOOD CONDITION; INCLUDES LIFT GATE (NEED TO VERIFY OPERATION); SMALL HOLE ON RIGHT REAR SEAM UNDER OPERATING INSTRUCTION LABEL

USED 26 x 102 x 118 VAN BODY, INTERIOR FRONT PASSENGER CORNER OF VANBODY HAS A REPAIR DONE, SCRATCHES ON OUTSIDE OF BODY ON PASSENGER SIDE NEAR REAR AXLE.

USED STEEL GRAINBODY WITH WOOD FLOOR UKNOWN IF OPERATIONAL REAR GATES HAVE HEAVY RUST TARP LOOKS TO BE IN GOOD CONDITION RUST THROUGHOUT

USED COMPLETE 10' X 36" GLEDHILLE PLOW, 3 TRIP SPRINGS, CUTTING SWATH @ 35 DEGREES IS 8' - 2-1/4", 10" MOLDBOARD OVERHANG, APPROXIMATELY 1859#; QCP HITCH AND CONTROLS INCLUDED; RUSTED IN VARIOUS AREAS (SHOWN IN PICTURES)

USED 24.5 FT X 102", INSIDE 98" X 103",WOOD FLOOR, TRANSLUSCENT ROOF, INCLUDES LIFTGATE, FRONT RIGHT CORNER CAP HAS DAMAGE AND CRACK NEEDS FIXED, MANY CROSSMEMBERS ARE RUSTED THROUGH

USED TOP LH CORNER HAS SOME PATCHING BOLT TOWARDS BACK ON BOTTOM OF BOX RIPPED OUT SLIGHT SCRAPES AND SCUFFS THROUGHOUT

USED INCLUDES LIFT GATE, NEED TO VERIFY OPERATION 26.5' X 102 X 110 VANBODY GOOD CONDITION

USED UNDER BODY IS RUSTED OFF RAILS, SCRAPES DOWN BOTH SIDES INSIDE WOOD ON WALLS HAVE HOLES MAXON 3300LB LIFTGATE THAT IS OPERATIONAL

USED 26'X96", 96"X92" WOOD FLOOR, HAS DENTS, CRACKS ON ROLL UP DOOR, CURBSIDE DOORS ON SIDES, FRONT LOWER NEEDS REPAIRS, DOES NOT INCLUDE LIFT GATE

USED ANTHONY 1500 LB OPERATIONAL RUST THROUGHOUT

USED SEAM ON ROOF LH SIDE INSIDE NEEDS RESEALED HOLE ON LH SIDE REAR HOLE RH FRONT BOTTOM CORNER LIFTGATE WAS TESTED AND IS FUNCTIONAL LIFTGATE PLATFORM 56X90"

USED 20' x 101" SUDENGA FEEDBODY, RUSTED THROUGH THE LEFT FENDER, BOTH FRONT CORNERS ARE RUSTED THROUGH, THE REAR UPRIGHT AUGER IS RUSTED THROUGH AND PATCHED WITH DUCKTAPE, THE MOTOR ON THE RIGHT AUGER RUNNING THE LENGTH OF THE FEED BODY HAS THE HYDRAULICS DISCONNECTED/BYPASSED.

USED INCLUDES HOIST AND CAB CONTROLS

USED COMES WITH TANK VALVE AND INSIDE CONTROLS MODEL SL-205

USED STORAGE BOX WITH LIFTGATE, LIFTGATE IS RUSTED THROUGH, ROOF HAS HOLES, SIDES ARE BENT, RUSTED ON UNDER SIDE

USED GODWIN STEEL DUMPBODY; RUSTED THROUGH SIDES AND MULTIPLE HOLES IN STEEL BOTTOM

USED 10'X96" STAINLESS DUMPBODY, DOES NOT INLCUDE CONTROLS

USED MULTIPLE HOLES ALONG FLOOR, RUST HOLES IN BED, ALONG BOTH SIDES AND TAILGATE (SHOWN IN PICTURES)

USED 12'6"X96" UTILITY ALUMINUM BED

USED 20' x 98" WIDE VANBODY, DOES NOT INCLUDE REEFER UNIT, INSIDE HEIGHT: 89",35" x 75" SIDE DOOR, 83" x 82" REAR DOOR, STEPS FOR SIDE DOOR BENT IN BOTTOM CORNER, 2 INCH CAVITY ON RIGHT SIDE NEAR FRONT OF BODY

USED 86 IN WIDTH, 24 IN HEIGHT, 8.5 IN THICK, BULLGRADER ONLY, DOES NOT INCLUDE FRAME, CYLINDERS, OR LINKS ID: 852542C91

USED 21.5'L x 96"W x 6"H(REMOVABLE), STEEL FLOOR W/ HEADACHE RACK, SENGAR 1230C WINCH, FLOOR HAS SURFACE RUST, A COUPLE SMALL HOLES IN FLOOR ALONG LEFT SIDE EDGE, WINCH CABLE WILL NEED REPLACED

USED POPPED SEAM AT TOP OF FRONT PANEL, 1 REAR DOOR PANEL NEEDS HINGES REPLACED ID:

USED

USED 10'L x 96"W STEEL DUMP BODY W/ 27" SIDE WALLS & HEADACHE RACK, TAILGATE SHOWS HEAVY RUST